• 191712_BallJoint Front Ball Joint Dust Boots
  • 191712_BallJoint Front Ball Joint Dust Boots
  • 191712_BallJoint Front Ball Joint Dust Boots

Front Ball Joint Dust Boots

Manufacturer: Prothane
Part Number: 191712_BallJoint


Price: $4.17

In Stock Ships Immediately


Ball Joint Dust Boots - Acura Integra

Pin Opening Diameter Base Opening Diameter Height of Boot Piece Number
(0.59 inch)
(1.375 inch)
(0.965 inch)
Here is our complete list of universal dust boots.
FitmentFront Ball Joint Dust Boots 191712_BallJoint fits these vehicles:
  • 2 - Tie Rod Dust Boots
  • Lifetime Warranty. Prothane guarantees all Prothane Suspension Parts to be free of defects in materials and workmanship (not due to abuse, neglect or misapplication) for the total time the vehicle remains with the original purchaser of the product(s). Should the products fail to meet these conditions, Prothane will replace the product, free of charge. This excludes any and all related labor charges. The product must be shipped to Prothane (postage prepaid) along with a copy of the original receipt."
  • Cross Reference from 191712_BallJoint to 9.13101Energy Suspension 9.13101
    Price: $3.64
    Warranty: 2 Year Warranty

Prothane Polyurethane Universal Dust Boots

Many of you are finding out that the rubber boot on your ball joint or tie rod has rotted away or has split. These boots are extremely important for the suspension of your vehicle. Fortunately, Prothane makes Universal Dust boots that will fit most vehicles. These dust boots are made of polyurethane and are far more durable than rubber. This will seal your boot to retain the grease in the joint, as well as protecting the joint from dirt, sand, water and snow.

Prothane Dust Boots

Prothane Dust Boots

How-to obtain measurements

In order to select the proper boot, you will first need to grab a few measurements. The best way to do this is with a set of digital calipers. You will need to measure the diameter of the base where the boot will sit, the diameter of the shaft (also called the Pin Opening Diameter) and the height of the boot. Once you have gotten to your tie rod end measure these three spots. Be sure to be as exact as possible and to write down your measurements. If you have any trouble getting these measurements, give our customer service team at DST a call.

It is important to note that you do not want to choose a boot that is bigger than your measurements. You want to choose a boot that is just slightly smaller than the measurements you obtained. The elasticity of the polyurethane will allow the hole to stretch and grip the joint tightly. If you choose a boot that is too large there will be a gap which lets in debris.

Does this boot match your needs?

Now that you have these measurements, you can verify that this is the boot that you need. If you find that your measurements do not match this boot, go to our Universal Dust Boot page to match a part to your measurements.

Prothane Dust Boots