unarchive In The Box of 61602 keyboard_arrow_down
- 2 of Metal Sleeves - 60598 (1.00 X .065 X 1.500 inches)
- 2 of Transfer Case Upper Mounts - 69002
- 2 of Transfer Case Lower Mounts - 69003
lock Warranty Information keyboard_arrow_down
- Lifetime Warranty. Prothane guarantees all Prothane Suspension Parts to be free of defects in materials and workmanship (not due to abuse, neglect or misapplication) for the total time the vehicle remains with the original purchaser of the product(s). Should the products fail to meet these conditions, Prothane will replace the product, free of charge. This excludes any and all related labor charges. The product must be shipped to Prothane (postage prepaid) along with a copy of the original receipt."
shuffle Cross References 1keyboard_arrow_down
Transfer Case Bushings - Ford Bronco - Prothane 61602
Product Reviews for Transfer Case Bushings - Ford Bronco - Prothane 61602
- 5 Star (3)
- 4 Star (1)
- 3 Star (0)
- 2 Star (0)
- 1 Star (0)
starstarstarstarstar" Quality parts "
It was hard to tell a whole lot,because my old bushings were wore out so bad I didnt have a lot to go by.The whole in my cross members were bigger than the protrusion on the bushings. I had to put two flat washers on top of each bushing buy new half inch bolts and nuts,but I believe they will work just fine.verified_user Verified Buyer - Rod Halford - . Prothane 61602 - 5 out of 5
starstarstarstarstar" Worth the Price "
Items are as good as they get. I actually sold these and re=purchased a s set of the red bushings. I did that only due to the fact that I changed out all the bushings on the truck and they are all red, so I wanted them to match, more vanity than anything else. I think even if it is a bit more expensive, you should include the large HD washer that I had to purchase separately and the oddball auto size bolts too with all metal lock washers. The 40 year old hardware is always in need of replacement and not all hardware stores even the good one carry that size bolt in grade or like I use on all my suspension F911s or grade 9s. Instructions would be helpful. Though not requiring and MIT degree it can be frustrating for the novice. Fact that a floor jack and wood to reach up to the transfer-case will not be obvious to any who have not changed these out. The confines are really tight if you do not have a body-lift to access the top nut or head depending on if the they have been tampered with in the last 40 years. Little to no access from the top unless you cut an access hole in the tunnel. I was lucky and didnt have to remove my front drive-shaft as the upper cardan was almost impeding the bolt from coming out. Common tools are all that are need except for some sort of high reaching jack and wood. will be good for another 40 after they are changed. Heres a thought no one produces a poly transfer-case snubber, not sure if only the early broncos have that part, but I would love to be able to replace with poly, in fact I am looking into modifying some other of your mounts to fit in there, why not be the only producer of it? Best of luck, Good product...Moverified_user Verified Buyer - Mauricio Mayorga - . Prothane 61602 - 5 out of 5
starstarstarstarstar" Very nice product! fit perfect. "
Very nice product! Fit perfect. Thanks for a product that works. Jackverified_user Verified Buyer - Jack Goodwin - . Prothane 61602 - 5 out of 5
Good parts. better than the OE parts that I replaced.verified_user Verified Buyer - Peter Zinck - . Prothane 61602 - 4 out of 5