• 191831 Ball Joint Dust Boots
  • 191831 Ball Joint Dust Boots
  • 191831 Ball Joint Dust Boots
  • 191831 Ball Joint Dust Boots

Ball Joint Dust Boots

Manufacturer: Prothane
Part Number: 191831
Rating 4 Reviews


Price: $5.37

In Stock Ships Immediately

FitmentBall Joint Dust Boots 191831 fits these vehicles:
  • Qty 2 of 60690 - 0.750 Top I.D. X 1.700 Bottom I.D. X 1.100 Height
  • Lifetime Warranty. Prothane guarantees all Prothane Suspension Parts to be free of defects in materials and workmanship (not due to abuse, neglect or misapplication) for the total time the vehicle remains with the original purchaser of the product(s). Should the products fail to meet these conditions, Prothane will replace the product, free of charge. This excludes any and all related labor charges. The product must be shipped to Prothane (postage prepaid) along with a copy of the original receipt."

Prothane Polyurethane Universal Dust Boots

Many of you are finding out that the rubber boot on your ball joint or tie rod has rotted away or has split. These boots are extremely important for the suspension of your vehicle. Fortunately, Prothane makes Universal Dust boots that will fit most vehicles. These dust boots are made of polyurethane and are far more durable than rubber. This will seal your boot to retain the grease in the joint, as well as protecting the joint from dirt, sand, water and snow.

Prothane Dust Boots

Prothane Dust Boots

How-to obtain measurements

In order to select the proper boot, you will first need to grab a few measurements. The best way to do this is with a set of digital calipers. You will need to measure the diameter of the base where the boot will sit, the diameter of the shaft (also called the Pin Opening Diameter) and the height of the boot. Once you have gotten to your tie rod end measure these three spots. Be sure to be as exact as possible and to write down your measurements. If you have any trouble getting these measurements, give our customer service team at DST a call.

It is important to note that you do not want to choose a boot that is bigger than your measurements. You want to choose a boot that is just slightly smaller than the measurements you obtained. The elasticity of the polyurethane will allow the hole to stretch and grip the joint tightly. If you choose a boot that is too large there will be a gap which lets in debris.

Does this boot match your needs?

Now that you have these measurements, you can verify that this is the boot that you need. If you find that your measurements do not match this boot, go to our Universal Dust Boot page to match a part to your measurements.

Prothane Dust Boots
Prothane 191831

Product Reviews for Ball Joint Dust Boots 191831

Prothane 191831

5 out of 5 based on 4 user reviews. Write a Review

I purchased this boot to fit the Moog DS1413 Track Bar for a 98 Ram 1500. I was a bit concerned that the size didnt match up when ordering and once it arrived, it slipped over with some stretch. Once installed it works perfectly fine. Note: I used a little ring of RTV on the base for grease control.
5 out of 5 - Good quality boot. Should last a very very long time.
Michael Long - . Prothane 191831
Fit properly.
5 out of 5 - Worked great
Dale Spires - . Prothane 191831
They worked for my ball joints.
5 out of 5 - Went on Easily and are of good material
John Hammel - . Prothane 191831
Ordered for my foxbody aje front lower tubular control arms. Fit perfectly and quality looks great. Would recommend.
5 out of 5 - Good quality and fit perfect
Tyler Self - . Prothane 191831
Fitment for 191831